CBF防爆軸流風機，CBF-300防爆軸流風機，CBF-400防爆軸流風機，CBF-500防爆軸流風機，CBF-600防爆軸流風機。

巨祥防爆公司網站https://www.jxfb.cn/商鋪網站https://www.jexfb.com/ 電話    手機：.,

【型號：CBF-300，風葉直徑300mm，功率0.18KW,主軸轉數1450rpm,風量2280;】
【型號：CBF-400，風葉直徑400mm，功率0.37KW,主軸轉數1450rpm,風量2880;】
【型號：CBF-500，風葉直徑500mm，功率0.55KW,主軸轉數1450rpm,風量5700;】
【型號：CBF-600，風葉直徑600mm，功率0.75KW,主軸轉數1450rpm,風量8700;】
【型號：CBF-700，風葉直徑700mm，功率1.1KW, 主軸轉數1450rpm,風量10200;】

詳細信息：
一、 CBF-300防爆軸流風機風機概述
CBF型防爆軸流式風機 ，用于輸送易燃易爆的氣體。葉輪由鋁合金加工而成， 以防止在運轉中引起火花, 電機采用隔爆型電機。
本系列風機適用于輸送易燃易爆無腐蝕性氣體，環境溫度不得超過60℃。 廣泛應用于一般工廠、倉庫、辦公室、住宅內通風換氣或強暖氣散熱，也可在較長的排氣管道內間隔串聯安裝以提高管道中的壓力 ，卸下電機可做自由風扇。風機需帶支架腳和電機電壓，請訂貨時注明。
二、 CBF-300防爆軸流風機風機安裝說明

◆ CBF-300防爆軸流風機安裝前應詳細檢查風機是否有損壞變形，如有損壞變形，待修理妥善后，方可進行安裝。
◆ CBF-300防爆軸流風機安裝時要注意檢查各不如部分有無松動，葉片與風筒間隙應均勻，不得相碰。
◆ CBF-300防爆軸流風機連接風口管道的重量不應由風機的風筒承受，安裝時應另加支撐。
◆ CBF-300防爆軸流風機 在風機風口端必須裝集風器，并安裝防護網。
◆ CBF-300防爆軸流風機 風機底座必須與地基平面自然接合，不得敲打底座強制聯接，以防底座變形，安裝時應校正機座，加墊鐵片、保持水平位置，然后擰緊地腳螺栓。
◆ CBF-300防爆軸流風機 安裝完畢后，必須先進行實驗，待運行正常后，才允許正式使用。
CBF-300防爆軸流風機主要技術參數

CBF-300防爆軸流風機，CBF-400防爆軸流風機，CBF-500防爆軸流風機，CBF-600防爆軸流風機。

A, CBF-300 explosion-proof axial fan blower Overview
CBF explosion-proof axial fans, used to transport flammable and explosive gas. The impeller is made of aluminum alloy processing to prevent spark caused in operation, motor flameproof motor.
Fans of this series is suitable for the transport of flammable and explosive non-corrosive gas, shall not exceed 60 ° C ambient temperature. Widely used in general factories, warehouses, offices, residential ventilation or the strong heating cooling interval longer exhaust pipe installed in series to increase the pressure in the pipe, remove the motor can be free fan. The fan bracket feet and motor voltage should bring, Please specify when ordering.
CBF-300 explosion-proof axial fan blower installation instructions

◆ CBF-300 explosion-proof axial fan installation should be a detailed examination of the fan if there is damage to deformation, deformation if damaged, to be repaired properly before installation.
◆ CBF-300 explosion-proof axial fan installation should pay attention to check the inferior part of the availability of loose leaves and duct clearance should be uniform, not touching.
◆ CBF-300 explosion-proof axial fan connected to the weight of the vent pipe should not bear fan hairdryer, plus support should be installed.
◆ CBF-300 explosion-proof axial fan in the fan outlet side must be installed a set of wind, and install protective nets.
◆ CBF-300 explosion-proof axial fan fan base and foundation plane natural bonding not beat base force join to prevent base deformation, the installation should be corrected base, plus horn piece, keeping the horizontal position, and then tighten the anchor bolts.
◆ CBF-300 explosion-proof axial fan is installed, you must experiment to be operating normally allowed to officially use.
The main technical parameters of the CBF-300 explosion-proof axial fan

CBF-300 explosion-proof axial fans, CBF-400 explosion-proof axial fans, CBF-500 explosion-proof axial fans, CBF-600 explosion-proof axial fans.