1、 注意保存，保存條件不好時，會降低膜片與反射殼（導光板）的粘附力。推薦保存條件為：溫度25℃&plun;10℃ 溫度65℃&plun;20℃
Store with care. Storing the units in bad conditions will cause the reflector sheet and decrease it’s Adhesive power. Storage the products under the Conditjon:temperature (25℃&plun;10℃) and humidity(65℃&plun;20℃ORH) our recommendation.
2、 焊接溫度260℃&plun;5℃，焊接時間小于3秒，烙鐵功率小于30W。
The Soldering tempwrature is260℃&plun;5℃and Soldering Time should be less than 3 sec, and soldering iron power should be less than 30W.
3、 焊接點應離產品實體大于1.6mm.
The soldering point should be farther than 1.6mm form body.
4、注意靜電，戴有繩腕帶，工作臺上要有靜電墊，設備、儀器要接地，電烙鐵、錫爐、波峰焊要接地。